Hi,
While calculating the Ipeak (peak primary-current) we use
Ipeak(pri)=(Vin(min)*Ton)/Lpri
If the voltage is say 100VDC minimum and 300VDC maximum , then Why are they calculating peak current from the minimum voltage . OTOH when the applied voltage ramps to 300VDC this peak current is substantial?
Thanks
-Adi
While calculating the Ipeak (peak primary-current) we use
Ipeak(pri)=(Vin(min)*Ton)/Lpri
If the voltage is say 100VDC minimum and 300VDC maximum , then Why are they calculating peak current from the minimum voltage . OTOH when the applied voltage ramps to 300VDC this peak current is substantial?
Thanks
-Adi