Hi Wade thanks for the response.
I have taken a look at that site and the one I'm trying to do is turn the LED on and off at some frequency. I encorporated what they have for blinking the LED on and off but this does not make the LED blink. I don't have a scope or I could verify if it's actually blinking but so fast I can't see it. Perhaps that's where I'm going wrong....I"m confused...but will take another look at it tonight. My code is below. I'm able to load it into the FPGA but the LED appears to be off all the time. Maybe I'm not defining clk correctly?
module LEDblink(clk, LED, SW);
input clk;
input [3:0] SW;
output [7:0] LED;
reg[32:0] cnt;
always @(posedge clk) cnt<=cnt+1;
assign LED[0] = cnt[22];
assign LED[1] = SW[0];
assign LED[2] = SW[1];
assign LED[3] = SW[2];
assign LED[4] = SW[3];
assign LED[5] = SW[0];
assign LED[6] = SW[0];
assign LED[7] = SW[0];
endmodule