Full Wave Bridge Rectifier

jb33

New Member
Hi All,
This is a silicon Full Wave Bridge Rectifier and I shot all 4 diodes with my DMM. I'm getting .488V drop through each diode. I was expecting something much closer to .7V. Does anybody think .488 is a bit low and may warrant replacement? Thank you in advance for your input!
 

Attachments

  • FWBR Datasheet.jpg
    1.3 MB · Views: 33
  • FWBR.jpg
    1.5 MB · Views: 32
No, a faulty rectifier won't have a low voltage drop, it will either be S/C, O/C or reverse leaky - it sounds perfectly fine.

If you put a high current through it, the voltage drop will increase, the tiny current from the meter is making it read much lower than it really is.
 
Some days I wish we had a "don't like" button instead of just a "like" button.
So do I

Thinking on, I'm sure there used to be one, it's pointless having one without the other.

It's probably part of this 'woke' crap!.

When we used to have work experience school kids at work, we had to write a report on how well they had done, and they altered the rules so you could only put positive comments. On one particularly useless child we had, I wrote "he turned up on some of the days, and wasn't excessively late on a few of those".
 
Last edited:
Cookies are required to use this site. You must accept them to continue using the site. Learn more…