A alphacat New Member Feb 28, 2010 #1 Hello. I'd like to start basically from zero to learn how to have an 8051 Uc to communicate with home Router through an Ethernet cable. Where shall I start from? Since its very new to me, i'd like to receive your guidance at this first stage. Thanks a lot. Last edited: Feb 28, 2010
Hello. I'd like to start basically from zero to learn how to have an 8051 Uc to communicate with home Router through an Ethernet cable. Where shall I start from? Since its very new to me, i'd like to receive your guidance at this first stage. Thanks a lot.
S sajivjess New Member Mar 11, 2010 #2 You need a Ethernet controller to connect the microcontroller to internet.
G gletchm New Member Mar 22, 2010 #3 Fred Eady did a lot with ethernet on a 8051. You need to find a ISA Ethernet card that is NE2000 compatible. also look at what edtp has. I have used there Packet Whacker. Welcome to the EDTP Electronics Online Store! Fred Eady has a book too. "Networking and Internetworking with Microcontrollers" by Fred Eady : 8051 Microcontroller Projects AVR PIC Projects Tutorials Ebooks Libraries codes I built a TCP/IP stack based on Fred Eady's Work. Lots of work. But fun. Last edited: Mar 22, 2010
Fred Eady did a lot with ethernet on a 8051. You need to find a ISA Ethernet card that is NE2000 compatible. also look at what edtp has. I have used there Packet Whacker. Welcome to the EDTP Electronics Online Store! Fred Eady has a book too. "Networking and Internetworking with Microcontrollers" by Fred Eady : 8051 Microcontroller Projects AVR PIC Projects Tutorials Ebooks Libraries codes I built a TCP/IP stack based on Fred Eady's Work. Lots of work. But fun.