it's me again, i need some body to help me with the switch,
here is the illustrate,
i need to turn on the 12 dc light bulb, but i need a switch with driven a rellay,
once i push the button 1 time the rellay are open (off) and again once i push the button the circuit driven rellay and rellay are on.
This circuit will do that. The resistor values are based on the relay I was using. For 12V supply, the relay can be either a 5V or 6V. Measure the coil resistance, and make the resistors approximately equal to that value. The capacitor value is not too critical. A smaller capacitor will work if the resistances are higher than shown.
it's me again, i need some body to help me with the switch,
here is the illustrate,
i need to turn on the 12 dc light bulb, but i need a switch with driven a rellay,
once i push the button 1 time the rellay are open (off) and again once i push the button the circuit driven rellay and rellay are on.