Help with IC PROG 1.05C message: "Device NOT blank at 0

Status
Not open for further replies.
J

jnewton

New Member
Starting in the world of uC, I have a JDM's like serial programmer and IC PROG 1.05C to "burn" the 16F84A and 16LF84A; but frequently I receive the notification (when charging the PIC) of "Programming failed at Code Address 0000h!" and, when verifying, even after erasing all the information, got the message
"Device NOT blank at address 000h!".
Please, somebody help me in order to save my PICS or do anything.... javascript:emoticon('')
Embarassed
 
Re: Help with IC PROG 1.05C message: "Device NOT blank


This error message is commonly caused by too little voltage on the MCLR pin, the JDM style programmers are VERY prone to this as they rely on your serial port being above RS232 standard to provide the required voltage.
 
Status
Not open for further replies.

Similar threads

J
  • Question
Why External Steering Request (XSR) J1939 message has checksum message within the 8-byte Data Field?
Replies
1
Views
3K
Diver300
D
  • Question
MPLABX device packs
Replies
9
Views
2K
Pommie
P
A
  • Question
STM32 DMA timer triggered at specific period with external trigger
Replies
2
Views
3K
ahmedragia21
A
K
  • Question
Help with STM32G0
Replies
2
Views
3K
rjenkinsgb
  • Question
The LCR T4 problem after the program firmware does not know the capacitor
Replies
8
Views
2K
electronium
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…