How to make Hex Workshop display 12-bit wide HEX data

Hi,

I am puzzled:

How to make Hex Workshop display 12-bit wide HEX data? It defaults to 8 and one can change it but NOT to 12 bit wide bytes, it goes from 8 to 16 and so on?

**broken link removed**

Why I need to display 12 bit wide words? Because on the low PIC parts the flash memory is 12 bit wide and if you display them as 8 then the whole addressing is offset?

I though this would be simple but.... no luck so far

The PicKit2 display those 12-bit wide words accurately, just as one would expect:

**broken link removed**

Although the pic only uses 12 bits of program data, it is stored in the hex file as 16 bits and so displaying 16 bit should give the correct values.

Mike.