how to program Atmega8a

J

jab99407

Member
I want to program Atmega8a. I have a 10 pin usb asp programmer. I have window 10 operating system. I want to use a Microchip Studio software IDE. I think I will have to install the GCC compiler with Microchip Studio. Microchip Studio generates hex files for the project.

I don't understand how to burn the generated hex file in the memory of the controller. What software tools would be required.
 

USBasp tutorial: Load program into ATmega microcontrollers - NerdyElectronics

USBasp is a USB in-circuit programmer for Atmel AVR controllers. It simply consists of an ATMega88 or an ATMega8 and a couple of passive components. The p..
nerdyelectronics.com

Fixing USBasp based on ATmega8

Cookies: AlxDroidDev: Is there anyway I can use my UNO do flash my USBasp with the newest firmware from USBasp - USB programmer for Atmel AVR controllers - fischl.de using my UNO R3 as the ISP ? Will that solve my problem? Yes, updating the firmware will solve your problem. Connect the...
forum.arduino.cc


The above should help.


Regards, Dana.
 
You must log in or register to reply here.

Similar threads

A
ATtiny85 upload on Sparkfun Tiny Programmer 11801 250502
Replies
1
Views
1K
danadak
Tutorial for AVR MCU programming for beginner
Replies
7
Views
4K
ahsrabrifat
A
W
Atmega8a PWM with TCNT1 issue
Replies
3
Views
5K
Ian Rogers
R
Help! Beginner in CodeVision AVR - How Turning On LED Based On Sensor Value?
Replies
5
Views
15K
rowan123
R
O
HDT22 sensor program not working
Replies
6
Views
8K
okbro
O
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…