How to shut down power control IC?

Status
Not open for further replies.
F

Flyback

Well-Known Member
Hi,
How do you best shut down the ICE2HS01G LLC controller?

You can either take the LOAD pin to ground...or take the VIN_SENSE pin to ground.......but the VIN_SENSE pin will make you wait 50us for shutting down, after its been grounded...whereas LOAD pin to GND gives instant shut down.

But VIN_SENSE only needs taking below 1.2V..whereas LOAD pin needs to be taken below 0.1V.....which may be impossible for a BJT.
So how would you shut down the ICE2HS01G?

ICE2HS01G

ICE2HS01G design guide
 
Sort by date Sort by votes
Thanks, though sect 3.10 concerns the Enable pin, which is a latched shut down, needing a power cycle to bring it back.......so my apologies, we are needing a non-latched shutdown.

Shorting SS to ground would increase the switching frequency, which is a step in the right direction.....and we could achieve that by shorting the FREQ pin to gnd aswell...but really, we want to stop it from switching............maybe shorting SS to gnd does that...hmmm...thanks for the info, ill look into it.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Z
  • Question
How to power on this weird circuit?
Replies
14
Views
3K
Zestfully4
Z
K
  • Question
How to determine wiring of DC motor controller
Replies
13
Views
2K
Diver300
D
S
  • Question
LTspice How to view the RMS value of waveform for power dissipation in Waveform Viewer.
Replies
4
Views
722
Lightium
J
  • Question
How does this fan control circuit from a PTC Ceramic heater work?
Replies
4
Views
578
JettTDi
J
S
  • Question
Amplifier shutting down
Replies
19
Views
4K
Nigel Goodwin
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…