gtr_stitch
New Member
I just recieved a TC7117 A/D Converter in the mail today and decided to wire it all up on my breadboard using the schematic in its datasheet, but when I apply power, nothing happens. There is a test pin, which works, but other than that, I'm stumped! Anyone help?
I know that I need an anlog input (hence a/d converter) and was advised to tie the analog pin high which would act as an analog input, but that didn't work either.
I added the schematic I used for reference. Any help would be awesome!
I know that I need an anlog input (hence a/d converter) and was advised to tie the analog pin high which would act as an analog input, but that didn't work either.
I added the schematic I used for reference. Any help would be awesome!