Hi when i try to program my 18f1320 it does the programming part then says verification failed at address 0x0000. Also all bits are set to 00 when ii read the IC.Is the IC permanently damaged?
Hi when i try to program my 18f1320 it does the programming part then says verification failed at address 0x0000. Also all bits are set to 00 when ii read the IC.Is the IC permanently damaged?
I've had that happen to on 18f1320 and 16f88 just force erase and she was good as new. The 16f88 has hung more. What's funny is it's only been when I use C18 on the 18f1320 and microC on the 16f88 the configure some how didn't set right. Like it didn't load it all when I programmed
I've had that happen to on 18f1320 and 16f88 just force erase and she was good as new. The 16f88 has hung more. What's funny is it's only been when I use C18 on the 18f1320 and microC on the 16f88 the configure some how didn't set right. Like it didn't load it all when I programmed
I will be moving to C in a couple of days, thanks for making me vary about the problem.
But i still think there is something wrong with the Ic cause i was forced to do it again.Will continue to do it though. These IC's are not available here.Had to import them.
The programs are correct since i test all my programs in Proteus to minimize debug problems.
Thanks for your replies.
Successfully used the UARt tool(tX ONLY).
But do i need to give the external supply a indicated in the PICKIT2 user's guide? Cause doing both Rx and Tx is causing porblems. Garbage data being transmitted and none recieved by the uc?