ICSP programming port

Z

zhizhi16

New Member

• Apr 24, 2004

• #1

Allo..


I have build and ICSP port on my breadboard to programming my microcontroller. What can i use to interface to this ICSP port? Is it some sort of serial to ICSP (5pins) cable i need to make?

Marcus

 

falleafd

New Member

• Apr 25, 2004

• #2

I don't remember exactly, but there was somewhere in this forum, chippie did post a helpful programmer. You can ask chippie for more information, or try to search. goodluck.

 

Exo

Active Member

• Apr 25, 2004

• #3

zhizhi16 said:

Allo..


I have build and ICSP port on my breadboard to programming my microcontroller. What can i use to interface to this ICSP port? Is it some sort of serial to ICSP (5pins) cable i need to make?

Marcus

Click to expand...

what breed of controllers are we talking about ?

 

Z

zhizhi16

New Member

• Apr 25, 2004

• #4

Silly mee.. didnt specify the MCU that im talking about.. im talking about a PIC16F877

 

Z

zhizhi16

New Member

• Apr 29, 2004

• #5

I checked out the forumn.. didn't find the ICSP posts useful..

Do i need to build something to interface it between my computer and PIC controller or can i simply from SErial to ICSP?

 

Exo

Active Member

• Apr 29, 2004

• #6

If you want to add ICSP to a project you must already have a pic programmer. The only thing you have to do is make a connection on your PCB (a plug) where RB6, RB7 and MCLR are connected to. (and RB3 if you use Low voltage programming). so you can connect your programmer to the pics programming port while it is still on the board.

 

ivancho

New Member

• Apr 30, 2004

• #7

You must also make sure that you add a diode to your MCLR pin, along with the "pull-up" resistor.