ICSP Programming question

Hi All,
I want to program a PIC16F726 device, The programmers I have are both by Olimex (Development and Prototype boards and tools for PIC AVR and MSP430 - their versions of PICSTART-Plus and ICD-2)
Both programmers have ICSP programming capability.
When I start a new project in MPLAB Project wizard, I can select the device and generate the code etc. (I use their assembler)
When I goto the Configure>Select Device to select the device, the PICKSTART Plus is indicated as 'RED' (hence not supported) and the ICD-2 indicates 'YELLOW' (only BETA supported ... not proven).
I would setup the chip on a bit ov vero to have an ICSP connection, but would I be able to send the code to it by selecting one of the other devices to actually program this one.
I have not examined the data sheet in any depth regarding the ICSP, but the PIC16F726 has the usual RB6 and RB7 clock and data lines and VPP pin, so I assume the programming spec would be the same.
I was thinking of generating the code, then selecting the PICSTART Plus programmer to send the code via the ICSP.
I just wondered if anyone could comment on this before I go ahead and probably fry a chip ?

Roy

You said the ICD2 had beta support for the chip you are using, use it.

That makes sense, use the beta option as this must work but with possible unknown bugs.

Thanks for the replies,
I'll give it a go.
Roy