Curious if anyone here is familiar with induction heating coils? We have some small parts we are trying to automate the heating of the tip of them. The problem is the parts are so small that the holding system to get them to the coil will be very close to the coil and we are concerned about interaction of the coil and the holders. The coil will need to be about 1" diam and would be about .25" from the holders.
Also, finding a way to automate getting these parts into a round or helical coil has created quite a problem. Just not an easy way to lower the coil or raise the part so I was curious about other coil types where the part could just pass by the coil and we could spin the parts? I am not sure if this will radically increase heating time either.