Krumlink New Member Jun 15, 2008 #1 Well I just ordered a 20$ unicorn, and I am ready to start playing with LCD's I was wondering even though there was a error on the PCB, what if I went around that trace? I do not see a issue about bypassing the error.
Well I just ordered a 20$ unicorn, and I am ready to start playing with LCD's I was wondering even though there was a error on the PCB, what if I went around that trace? I do not see a issue about bypassing the error.
blueroomelectronics Well-Known Member Jun 15, 2008 #2 You can cut the trace on either side of the transistor base and jumper it if you like, this will allow use of LED1
You can cut the trace on either side of the transistor base and jumper it if you like, this will allow use of LED1