All,
I am building a DC power plant for a small telco operation, and have some questions as to
operation of the inverters.
We are using RA-62 rackmount frames that house 3-30 amp 48 volt inverters.
The documentation on them is not clear on the DC fail output lamp functionality.
Currently, I have the inverters operational, but get a DC fail output lamp even when all operating parameters seem correct.
I am operating them in both a stand-alone, and paralleled operation using the IShare bus for load sharing. Both combinations light the DC fail lamp.
At this time, the load on any one bus is probably less than 3 amps @48VDC output. I would really like to solve this before I commit the system to them.
Has anyone ever used this product and can shed some light on the operation of the DC fail detector circuit?
Thanks
Dialtone
I am building a DC power plant for a small telco operation, and have some questions as to
operation of the inverters.
We are using RA-62 rackmount frames that house 3-30 amp 48 volt inverters.
The documentation on them is not clear on the DC fail output lamp functionality.
Currently, I have the inverters operational, but get a DC fail output lamp even when all operating parameters seem correct.
I am operating them in both a stand-alone, and paralleled operation using the IShare bus for load sharing. Both combinations light the DC fail lamp.
At this time, the load on any one bus is probably less than 3 amps @48VDC output. I would really like to solve this before I commit the system to them.
Has anyone ever used this product and can shed some light on the operation of the DC fail detector circuit?
Thanks
Dialtone