A arvinfx Member Apr 1, 2010 #1 Hi, I must build a dc motor driver with Turn Right - Turn Left and BRAKE . The l293 have only fast stop and when motor release free!!! How can i brake the dc motor? Last edited: Apr 1, 2010
Hi, I must build a dc motor driver with Turn Right - Turn Left and BRAKE . The l293 have only fast stop and when motor release free!!! How can i brake the dc motor?
ericgibbs Well-Known Member Most Helpful Member Apr 2, 2010 #2 arvinfx said: Hi, I must build a dc motor driver with Turn Right - Turn Left and BRAKE . The l293 have only fast stop and when motor release free!!! How can i brake the dc motor? Click to expand... hi, Are you asking for a way for the motor to hold its position after stopping even when there is an external turning force being applied to the motor shaft.? How are you controlling the L293.? Last edited: Apr 2, 2010
arvinfx said: Hi, I must build a dc motor driver with Turn Right - Turn Left and BRAKE . The l293 have only fast stop and when motor release free!!! How can i brake the dc motor? Click to expand... hi, Are you asking for a way for the motor to hold its position after stopping even when there is an external turning force being applied to the motor shaft.? How are you controlling the L293.?
Hero999 Banned Apr 2, 2010 #3 You need to use a stepped motor to lock up completely. The L293 features a break, see figure 9 on page 6 of the data sheet. **broken link removed** Attachments h-bridge motor L2.PNG 11.8 KB · Views: 2,610
You need to use a stepped motor to lock up completely. The L293 features a break, see figure 9 on page 6 of the data sheet. **broken link removed**
A arvinfx Member Apr 2, 2010 #4 It is down now. i set my motor on for 25us and 25us off then i unuse it and brake happened.
M mic5 Member Apr 7, 2010 #5 arvinfx said: It is down now. i set my motor on for 25us and 25us off then i unuse it and brake happened. Click to expand... use chip select to low will be useful to brake the motors. i think this is enough to run and off the motor for your desired time.
arvinfx said: It is down now. i set my motor on for 25us and 25us off then i unuse it and brake happened. Click to expand... use chip select to low will be useful to brake the motors. i think this is enough to run and off the motor for your desired time.
magnatro New Member Apr 8, 2010 #6 you can brake the motor simply by making the inputs to the driver to the same logic???