I am using an STP16C596 as a constant current LED driver. I am not interested in using any logic, I just want the device to turn on all channels all the time. I used a similar device in the past, a Toshiba TB62701AN. I simply set SDI (serial data input) and OE (output enable) high on the device and it turned on all the channels without a CLK signal. On the STP16C596, it seems like I need to set SDI high, send 16 pulses on CLK, set LE (latch) high, and then set OE high. This prevents me from using the STP16C596 as a stand alone LED driver. Is there a state I can set on all these inputs to simply turn all channels on all the time? Your help is much appreciated.
Deebo