Hi
folks , i want to know if installing a lever of about five inches between a 12DCV actuator and the load will cause a decrease in the torque significantly?The torque is rated at 400 IbS with a stroke length of 10'' from progressiveautomations.The linear actuator is going to be at the top with the load beneath with a pivot in the middle.
I don not want the torque to be decreased. Does anybody have any experience in this regard.
Kwame
folks , i want to know if installing a lever of about five inches between a 12DCV actuator and the load will cause a decrease in the torque significantly?The torque is rated at 400 IbS with a stroke length of 10'' from progressiveautomations.The linear actuator is going to be at the top with the load beneath with a pivot in the middle.
I don not want the torque to be decreased. Does anybody have any experience in this regard.
Kwame
Last edited: