I have added a nother Circuit to the LM 317 which is working now I placed the Resistor in the circuit.260 ohm Resistor.
The Circuit I have added is a High Current with the Regulated Voltage I have tested the circuit with 30 V DC Input.
I am getting 27 Volts out of the voltage regulated circuit and adjusting the 5K pot down to the lowest reading I get .750 Volts
When I place the digital metre into the High Current circuit at 30 Volts DC input into the circuit I get a Reading of 10.3 volts and adjusting the pot to the lowest reading I get 2.7Volts.
I have combined 2 circuits together.
The circuit I used for the High current is on the net but have changed the circuit.
http://www.reuk.co.uk/High-Current-Voltage-Regulation.htm
I am looking for 27Volts out at 12 AMP to drive a led light with 200 leds in the unit.I am using a DC battery to get the required power.
I will post photoes of the unit
Hope you can help me.
I the last photo you will see I have added a resistor and the brown wirer
This may help you to see under the resistor and wirer
I have not loaded the Circuit up at this stage.
If you require a photo of the solder side of the circuit board I can provide that