Hi,
I am using a LM2676S-ADJ regulator, this reg has a ON/OFF pin that I would like to use reset my entire circuit via a PIC then have anice delayed power on giving a orderly startup again. I have put a RC on this pin but I am a bit worried that I will cause problems by setting the delay too long.
Any advice on how long I can hold this regulator off using the RC without causing problems with the regulator due to the RC?
The reason I'm asking is because I was looking at the LM2576 and this mentioned problems regarding long delays using a RC. Here on page 19 https://www.electro-tech-online.com/custompdfs/2005/03/LM2576.pdf and I wondered if this applied to the LM2676 also even though it's not mentioned in the LM2676 PDF