LTSpice error: "DC Sweep: Source 'Vcc' was not found."

electrolives

New Member

• Nov 29, 2018

• #1

Is there anyone can help me about that how can I put Vcc on the simulation? Thanks

 

alec_t

Well-Known Member

Most Helpful Member

• Nov 30, 2018

• #2

Add a DC voltage source of arbitrary value to your schematic, call it Vcc and connect it between ground and your Vcc point.
Then add the statements specified.

 

MikeMl

Well-Known Member

Most Helpful Member

• Nov 30, 2018

• #3

It is simpler than you think..

.