LTSPICE opamp circuit sim

I'm trying to sim the input circuit of an audio EQ, but I'm getting only DC at the output.

This is what I'm trying to simulate:



It's the input section of this schematic:



Here's what I've created, the .ASC is attached:




I'm using an LT1057 model as it is described as a drop-in replacement for the TL072, and I'm assuming it's enough to get me in the same ballpark for what I'm trying to achieve. I've successfully simmed tube circuits but this is my first go with an opamp. What am I missing? I've tried searching for an explanation of this type of circuit but I haven't been able to find one. Please be gentle on me as we pop my cherry.

There's an error in the original circuit schematic: pins 5 and 6 have been transposed. Pin 5 should be the non-inverting input.

You are using the wrong inputs. See picture below.
The signal goes to the (+) and the feed back toes to (-)

The first picture in post #1 is wrong. Like many schematics on the internet. (and much of the politics. … wrong and backwards)

Thank you both for your help! What's kinda funny is that I got the schem directly from the manufacturer.

potency said:

What's kinda funny is that I got the schem directly from the manufacturer.

Click to expand...

It's not unknown for manufacturers to deliberately include errors in their documentation, to detect copyright infringement and deter counterfeiters. In this case, though, it's more likely a simple typo.

potency said:

schem directly from the manufacturer

Click to expand...

The lines on the schematic and the traces on the PCB are right. Pins 5,6,7 are right. The "+" and "-" on the part are wrong.
On all amps I have seen the (-) pin is next to the output pin.