No diagram, but it's a very simple circuit. Only 2 pins on PORTB are being used, one for the LED and one for the FM module data line (wired straight to the PIC pin, if that might cause issues?). None of the other PORTB lines are tied to GND, because that has never caused me problems before.
Datasheet for the FM module **broken link removed**.
Aside from this the only thing connected is power. I can get a diagram done tonight if that would be helpful.
I should also mention that it works fine when the ICD is plugged in and connected to the Junebug (even if not in development mode). This only involves connections to +3.3v, GND, PGC, PGD and MCLR. So I'm not ruling out an MCLR issue, but I don't see why my magic finger would fix that!