Using a push button I have made a push to make switch like the one below. (sorry for horrific art skills). Could anyone show me using a similar diagram how to change it into a push to break switch. **broken link removed**
Using a push button I have made a push to make switch like the one below. (sorry for horrific art skills). Could anyone show me using a similar diagram how to change it into a push to make switch.
A push to make or push to break switch is usually referred to as a normally open or normally closed push button switch. This is a mechanical attribute that is built into the switch and cannot be changed. If you have a single pole double throw push button switch you can have either normally open and normally closed operation depending on what switch terminals you wire to.
Now if what you really are after is how to change your switch wiring so that the logic level presented to the signal output is normally high, 9vdc, rather then ground then that is another question.
Using a push button I have made a push to make switch like the one below. (sorry for horrific art skills). Could anyone show me using a similar diagram how to change it into a push to break switch.