Microwave Sensor in conjunction with Philips LCM system.

[GT-Rpaulie]

When motion is detected by the microwave sensor it closes a volt free contact, 2-core beldon goes back to an LCM which inturns switches and input, pulls in a mains contactor a brings on the lights(through bus-bar trunkin)
I need to install some sort of a pulse on and pulse off relay that can be connected between the volt free contact (sensor) and the LCM. Any info would be much appreciated.
Thanks
Paul

 

[moffy]

Sounds like you need a latching relay with a reset. You can do it easily with just 2 ordinary relays.