Been a while...
Another question for the pros here.
Control System Problem
If I told you I had a single phase motor with:
3 leads, one common, one forward, and finally, one reverse, and I was having a controls issue, and just for grins I measured the voltage between each of these leads, and ground, and got a 220VAC. Now, the motor is NOT running, it is NOT bad, and it is not drawing current, what would you say it was? How is this even possible?
I am baffled... I have this Beckwith:
The Control This is where I thought the problem was, but I have a manual control that circumvents the Beckwith tap changer, that will not operate the motor either, yet, again, there is 240 between each of the motor leads and ground???
Your thoughts are appreciated as always.
Thanks