Hello everyone, I just recently just bought a device that allows me to receive GSM (cell phone signal) in a site where cell phone signal is not detected by regular cell phones. The device works fine for approximately 15 minutes and then it freezes. By turning the device off and on again it works again for another 15 minutes. I then installed a wireless phone that allows me to move around and still be able to use the phone. However, since the signal device only works for 15 min. approx., I have to go and reset it for it to work again. I have tried many devices and this is the only one that I've found able to detect some signal (therefore I would like to make it work). The device works with 110v input. I wonder if there may be a simple circuit that could allow us to leave this device connected to the 110v power permanently and have it reset every 10 minutes (i.e., turn it off and on) so that I don't have to go and reset it every time I want to use it. It would be ideal if the circuit could also wait 2 seconds before turning it back on. Can somebody help me design this circuit? A friend told me to buy some parts and I have bought some including a 555, a 556, and a protoboard. However, if these are not needed I can take them back. Thanks a lot...