I will have to give JCBPCB a try. I have the greatest respect for Nigel. Though I show as a new member here now, i was here quite a bit when the site used the old format, and I have seen what Nigel's insight and knowledge bring to the table. I had some time away due to medical issues, and even now I am only here occasionally, but I do try to contribute when and where I can.
As to the kudos on the board, I must admit that it is not my design, but is one that I DL'd from GitHub. It was posted there by a member of the element14 forum known as shabaz. The PCB is for a handheld tachometer that I decided to use as a training item for a group here in south Jersey. I mainly wanted to use it as a primer for the group in the use of the MSP430G2553 microprocessor from TI, and I didn't want the group to get mired down in trying to build it on a perfboard or proto-board. Hence, the PCB. I did have to modify the Gerber file to get it into the RS-274x format, so that it would be accepted by the board makers. Apart from that, the board is as the designer presented it. So... the kudos rightly go to shabaz rather than to me.