AtomSoft
Well-Known Member
Hey i just found a old PS2 memory card labeled 32MB but i opened it and checked the chip and the datasheet says its 64MB. Either way im going to try and make a interface for this card so i can use it as memory. Just a little project.
http://www.datasheetcatalog.org/datasheet/toshiba/1751.pdf
Shouldnt be to hard as its a Parallel interface and the only issue i will have is that the max VCC = 3.6v and i only have 5v pics.
My Main question:
Would i have to use like a voltage divider for each data pin?
http://www.datasheetcatalog.org/datasheet/toshiba/1751.pdf
Shouldnt be to hard as its a Parallel interface and the only issue i will have is that the max VCC = 3.6v and i only have 5v pics.
My Main question:
Would i have to use like a voltage divider for each data pin?