hi thanks for looking in, im looking at a servo controller at the moment that just moves left to right with a 16F84
sorry for being thick but what type of PIC language is this? as it looks very different from the LED programs i have seen
Also do i not need to set header and the equates or do i not need it in this case. Any help of what i would need to add to this program to get it running would be much appreciated. sorry i am very new to this
this is what i have to work with
----Listing 1----
' First servomotor program
' Sweeps left to right, then reverses
Symbol B1 = pw ' create a variable pw
pw = 100 ' start at extreme left
sweep: pulsout 0,pw ' send pulse to motor
pause 18 ' set frequency to about 50 Hz
pw = pw + 1 ' increase pw by 1
if pw > 200 then back ' at extreme right, turn CCW
goto sweep ' otherwise, continue
back: pulsout 0,pw ' send pulse to motor
pause 18 ' set frequency to about 50 Hz
pw = pw - 1 ' decrease pw by 1
if pw < 100 then sweep ' at extreme left, turn CW
goto back ' otherwise, continue
----End of Listing 1----
what lines if any do i need to add?
would MPLAB be suitable?
thanks again
thanks for your time