Hey everyone, I bought and assembled an inchworm a few months ago and I am going CRAZY trying to get it to debug or program.
It seems entirely unable to program a chip. When I am in programming mode, I don't get any errors, but the chip reads 0000 across the board, even after programming.
In debug mode, I get the following error:
ICD0161: Verify failed (MemType = Program, Address = 0x0, Expected Val = 0x2826, Val Read = 0x0)
ICD0275: Programming failed.
I think it probably has something to do with configuration (I am using a PIC16f88):
_CONFIG _CONFIG1, _CP_OFF & _CCP1_RB3 & _DEBUG_ON & _CPD_OFF & _LVP_OFF & _BODEN_OFF & _MCLR_ON & _PWRTE_ON & _WDT_OFF & _INTRC_IO
_CONFIG _CONFIG2, _EISO_OFF & _FCMEN_OFF
Any ideas? Please?