Hi,
Whenever I try and measure a constant DC voltage on my oscilloscope (HP 54501A 100MHz digitizing oscilloscope), it always takes about three sweeps of the screen to get up to the actual voltage (will upload video of necessary).
Is there a way to get a straight line to go to the voltage you want immediately?
I think its something to do with the trigger but don't think it's possible to turn the trigger off.
Any ideas?
Thanks very much,
Froskoy.
Whenever I try and measure a constant DC voltage on my oscilloscope (HP 54501A 100MHz digitizing oscilloscope), it always takes about three sweeps of the screen to get up to the actual voltage (will upload video of necessary).
Is there a way to get a straight line to go to the voltage you want immediately?
I think its something to do with the trigger but don't think it's possible to turn the trigger off.
Any ideas?
Thanks very much,
Froskoy.