hi every body ..i want to operate between 220VAC to 230VAC .and want to step up when voltage goes low from 220 VAC and want to shut down my system when voltages goes high from 240 VAC ...can anybody help me ???
I believe the op means when the voltage goes below 220VAC and above 240VAC.
Stepping voltage up requires a transformer, typically an autotransformer with taps for this type of application. You then need a circuit that detects the voltage and switches a relay to select the proper tap.
Such a transformer can also have taps to step the voltage down, so you can continue to operate when the voltage is too high.
They are a self regulating type of constant voltage output transformer that can take a wide range of input swings of usually minus 25% to plus 15% and give a constant voltage output with a less than +- 1% variation over that input range.
What is causing the voltage to go up and down? Why not fix that problem?
Is it caused by somebody sleeping instead of working at the electricity supply place?
i am going to design stabilizer to supply fix 220 VAC to 230VAC ..if source voltage is less then 220 VAC then my system should step it up and if voltage goes up from 230 VAC i.e .240 vac or more then my system should get off to protect my device for damage ....i have got the answer for over voltage and it works , i used comparator for it but still want some guide what should i do for step up if voltage comes less than 220 vac