Hey i got my P16PRO40 board. It says 17-30VDC or 13-20VAC
Either of those goes into the same (hole/pin) ??? I found that rather strange.
How can one power hole be used for AC or DC. can someone please clarify this thing for me. Also one more question. When PRogramming on the P16PRO40, is it wise to try to somehow connect the pins of the sockets that the chip is being programmed on, to connect those pins to a breadboard using really reallly thin wire? This way the PIC can stay on the P16PRO40 and basically the i/o pins are brought out to a breadboard. Is that something to do, or should i always remove the PIC from the programming board?
thank you
Either of those goes into the same (hole/pin) ??? I found that rather strange.
How can one power hole be used for AC or DC. can someone please clarify this thing for me. Also one more question. When PRogramming on the P16PRO40, is it wise to try to somehow connect the pins of the sockets that the chip is being programmed on, to connect those pins to a breadboard using really reallly thin wire? This way the PIC can stay on the P16PRO40 and basically the i/o pins are brought out to a breadboard. Is that something to do, or should i always remove the PIC from the programming board?
thank you