justDIY
Active Member
I'm having some major frustration trying to do a rather large board (3.5" x 2") with PNP Blue.
Whats happening is air is getting trapped or formed under the plastic sheet, and results in little air bubbles. so I'm left with voids.
any suggestions for getting rid of the air bubbles? I've tried starting my iron on one side and moving in a single direction, to give them room to escape, but it doesn't seem to make much difference
Whats happening is air is getting trapped or formed under the plastic sheet, and results in little air bubbles. so I'm left with voids.
any suggestions for getting rid of the air bubbles? I've tried starting my iron on one side and moving in a single direction, to give them room to escape, but it doesn't seem to make much difference