peugeot motorscooter problems

Status
Not open for further replies.
S

speciess

New Member
Hi there amigos...i have one peugeot elystar motorscooter which i guess the ecu is terminated and i do a lot a work to separate the electronic board from that foam.
Now...what think can tell me the processor is dead?and also i have one electronic component in the board i can not indentify.i try to upload a photo if somebody will help me
the blue component is one mister for me...
 

Attachments

  • IMG_5575.JPG
    3.6 MB · Views: 195
It may be a symptom of other faults too (The failure of the coil is most likely caused by the failure of another part). You'll have to clean more of the foam off to see better and maybe spot other burnt parts. The problem is that not all failed components will appear burnt. The copper coloured area next to the coil may indicate heat damage unless you scraped that bit bare when cleaning the foam off. What does the other side of the PCB look like?
 
Last edited:

Thx for reply...today i will work to remove all the foam.i will upload also the other side of the PCB where i find one blowed diode right in the opossite part of the coil
 

Attachments

  • IMG_55834.jpg
    1.9 MB · Views: 178
speciess said:
where i find one blowed diode right in the opossite part of the coil
Click to expand...
It looks more like a capacitor to me. Usually a SMD diode will have some sort of a marking code on it or a line drawn at one end to indicate the cathode.
 
Status
Not open for further replies.

Similar threads

7
  • Question
problems getting M74HC259B1R to work
Replies
18
Views
3K
777xxx
7
C
  • Question
L293D MOTOR CONTROLLER PROBLEMS
Replies
9
Views
4K
tepalia02
T
C
Tektronix T932 oscilloscope problems
Replies
0
Views
1K
Cello
C
B
  • Question
power supply problems
Replies
5
Views
2K
bubblehead1
B
  • Question
OTA based circuit problems
Replies
11
Views
2K
Fluffyboii
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…