hi all
i want to control dc-motor by pic using pwm
the pwm signal will trigger the mosfet gate
the mosfet which i will use the Vgsth=()2Vmin.-4Vmax.)
my question is :can i connect the mosfet gate directly to the pic output without using mosfet driver?
from the datasheet the mosfet is saturated at Vgs=10V
so i think i should apply voltage to Vgs between 5-7V.
and i want to know if that mosfet is good to drive motor which current is 6A?
i attached the mosfet data sheet and the circuit diagram.
i want to control dc-motor by pic using pwm
the pwm signal will trigger the mosfet gate
the mosfet which i will use the Vgsth=()2Vmin.-4Vmax.)
my question is :can i connect the mosfet gate directly to the pic output without using mosfet driver?
from the datasheet the mosfet is saturated at Vgs=10V
so i think i should apply voltage to Vgs between 5-7V.
and i want to know if that mosfet is good to drive motor which current is 6A?
i attached the mosfet data sheet and the circuit diagram.