it can be used for 16F84, 16F62X, 16F87X chips
To make it:
TXD (3) ------[4.7k]-------VPP
GND (5) --------------------VSS
DTR (4) -------[4.7k]------DATA
CTS (8) ------------------DATA
RTS (7) -------[4.7k]------CLK
Numbers in Bracket are the connections on the 9-Pin D-Connector.
Then just put your PIC into a breadboard, connect your 5 volt supply to VDD/VSS, and away you go.
for the software ;
use IC-prog
IC-Prog
i think we should make this become sticky thread
so the other beginner will not asking again