George L.
New Member
Hello,
I built one of those simple JDM programmers to work with the 16F628, to do some tutorials on Nigels site.
I downloaded the 1st programmer on the IC-PROG page and plugged in my programmer to my serial port...
The problem is I can't change anything in assembler mode, what the seceret?
thanks,
George L.
I built one of those simple JDM programmers to work with the 16F628, to do some tutorials on Nigels site.
I downloaded the 1st programmer on the IC-PROG page and plugged in my programmer to my serial port...
The problem is I can't change anything in assembler mode, what the seceret?
thanks,
George L.