Hi there,
Recently purchased a velleman pic programmer for n00bs from Maplins.
Managed to work out how to make an LED come on after pushing a button.
Now I am wondering:
How much voltage does the PIC put out when a pin/leg goes "high"?
And how would i go about making a motor come on, as they draw a constant current that is far more than an LED?
I purchased a mini 5Volt relay (pcb mountable), which i was thinking i could have switch the motor on or off?
Any advice welcomed, also what are your thoughts on these DC motor controllers (out of the box, or kit form)?
Cheers,
Paul
Recently purchased a velleman pic programmer for n00bs from Maplins.
Managed to work out how to make an LED come on after pushing a button.
Now I am wondering:
How much voltage does the PIC put out when a pin/leg goes "high"?
And how would i go about making a motor come on, as they draw a constant current that is far more than an LED?
I purchased a mini 5Volt relay (pcb mountable), which i was thinking i could have switch the motor on or off?
Any advice welcomed, also what are your thoughts on these DC motor controllers (out of the box, or kit form)?
Cheers,
Paul