Potentiometer with fixed center point

Status
Not open for further replies.
M

mcs51mc

Member
Hi,
Any idea where to buy a 100k 2 gang linear potentiometer with fixed center point?

Between pins 1&2 always 100k
Between 1/4 & 2/4 always 50k
Between 1 to 3 normal 100k potentiometer

This part is used in an audio amplifier and needs to be changed.
No idea if this is the correct name of this part so rather hard to search the net.

Thanks for your inputs... ...
 
If you can't source a replacement, then connection 4 could perhaps be taken from a pair of 50k (or higher) resistors in series across the pot.
 

These were usually used for 'loudness' correction, basically increasing the bass and treble at low volumes - considering the lack of availability of pots in general now I would imagine it might be difficult to find, other than as a spare part from the manufacturer of the unit.

However, fitting a normal pot without the tap should be fine, and you probably won't notice any difference.
 
alec_t said:
If you can't source a replacement, then connection 4 could perhaps be taken from a pair of 50k (or higher) resistors in series across the pot.
Click to expand...

That might work but depends on how the connections are arranged in the circuit and the current draw of each. If pins 3and 4 are connected, the 50k divider adds an issue
 
Wouldn't a standard 100k pot with two 50k resistors do the same job?

Mike.
 
Thanks for the reactions!

Manufacturer is not an option, already contacted a few years ago for the “Balance” pot meter.
That one I replaced with fixed resistors.

I don’t think one can build such circuit with a few resistors and a standard pot meter.
At least I couldn’t think of any.

I’ll try as suggested by Nigel without using pin 4 at all.
 
Pommie said:
Wouldn't a standard 100k pot with two 50k resistors do the same job?
Click to expand...

No, I thought LONG and HARD about this MANY years ago, as such silly pots weren't ever available for very long. If you think abut it, adding two external resistors won't be affected by adjusting the volume, which is what the whole idea is.

However, the balance control could easily be replaced by a none tapped control, as it's not really doing much anyway. The Loudness control is switchable, so if he didn't have it switched ON anyway, it won't make any difference to him.
 
If you examine how the pot functions with the external loudness RC circuit, you would see that adding two 50k ohm resistors across the pot will not give the same output as the tapped pot.

How about this pot.
It has a 40% loudness tap instead of 50%, but that should operate very similar to the original pot (difference probably inaudible).
 
Status
Not open for further replies.

Similar threads

M
  • Question
Controlling servo motor wirelessly with a potentiometer
Replies
11
Views
1K
aliarifat794
A
C
  • Article
Grundig RR315 no fast forward/reverse but output fixed
Replies
0
Views
539
carolmaille
C
  • Question
Digital potentiometer problem and questions
Replies
7
Views
7K
GH Crash
N
  • Question
HELP WITH LOGIC CIRCUIT
Replies
10
Views
1K
JimB
J
  • Question
Where to add a potentiometer to vary input voltage?
Replies
15
Views
2K
Jim Kailey
J
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…