Power UP (POR) VS MCLR Reset

Status
Not open for further replies.
S

Suraj143

Active Member
I’m doing these three steps in my PIC after org 0000h statement & I’m not clearing any ram.

1) After power on I’m checking a special GP registers value after org statement. So After power up it will show zeros.

2) In my main code I’m modifying that special GP register.

3) Now I’m resetting my PIC by MCLR pin. (not power off)

Now what will be the value of that register? Does it clear or still remains on the last modified value?

Thanks
 
There is no simple answer.

What the bit values are after POR or MCLR reset are detailed clearly in the datasheet. Sometimes within a register only a single bit remains unchange. For others a single bit changes while the bits stay the same.

You need to refer to the datasheet on sections "Special register Summary" and "INITIALIZATION CONDITION FOR SPECIAL REGISTERS".
 
There is no special GP register, only General Purpose register.

You are on your own to set or clear them. The PIC won't do it for you. The values they contain can be anything upon power ON and relying on them to be a fixed value(zero) without initialising is plain stupid. These registers will hold their values when power is healthy.
 

You shouldn't rely on hoping registers maintain their values through a reset, you should ALWAYS initialise then in your startup routine.
 
If you simply want to know if a power on occurred or reset was pressed then there are bits in the Status register for that purpose. A simple way to know is to check bit 3 of status, if it's set then it was a power on reset and you need to clear it, if it's clear then you pressed the reset button. Note, if you don't clear it after you check it then it will stay set after you press reset.

Mike.
 
Thanks for the replies guys.


This is my attempt I'm trying to detect whether a MCLR reset has occurred or power on reset has occurred.Earlier I did that with a GP register.But there is a dedicated bit for that purpose.

Thanks for that.
 
Pommie said:
If you simply want to know if a power on occurred or reset was pressed then there are bits in the Status register for that purpose. A simple way to know is to check bit 3 of status...
Mike.
Click to expand...

Wrong.
Excluded the use of PCON register.
 
I stated a simple way to know one from the other. As the OP is a beginner testing bit 3 of STATUS will suffice. Adding complications like PCON is just likely to confuse.

Mike.
 
Status
Not open for further replies.

Similar threads

MPLAB X heads up
Replies
6
Views
3K
Nigel Goodwin
Common MCLR
Replies
17
Views
2K
For The Popcorn
B
Reset
Replies
5
Views
2K
Nigel Goodwin
W
  • Question
ESP32 30pin vs 38 pin boards
Replies
0
Views
5K
Wp100
W
D
  • Question
SAA1057 PLL Synth code-Can it be improved/tidied up?
Replies
9
Views
657
djsb
D
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…