mramos1
Active Member
I pulled out the old pic programmer (and shhh, some 18F64) chips.
I can erase and read fine, but can not program the chip.
I get a verify error at 0x000. I will look for the schematics and scope, but figure I would post in the event there is setting I might have missed. I did reset the
power and also try on a couple new PICS from a once new tube.
I can erase and read fine, but can not program the chip.
I get a verify error at 0x000. I will look for the schematics and scope, but figure I would post in the event there is setting I might have missed. I did reset the
power and also try on a couple new PICS from a once new tube.