Hello, new to this forum, bit of a novice in this field. I have a metal sensing proximity sensor that I would like to use to switch an air solenoid for an autoclave door seal safety device. I assume that I will need to interface this sensor to some kind of SSR to step the signal up to actually switch the solenoid, which is about one amp. The prox sensor is a 12- 24VDC. I am not good at reading circuit diagrams, a description would be possibly better for me to get a grasp on the details if possible. I can provide more details but need to know what is wanted. Thank you to all in advance!
DaveA.
DaveA.