Pulse wave moduation

J

josephkim87

New Member

• Sep 2, 2006

• #1

I wish to send a PWM signal into my motor driver from an RF circuit. I'm using a PIC microcontroller for this..I'm still quite blur on how it all works. Some advice would be helpful please. How can you control the PWM signal with RF?

 

bananasiong

New Member

• Sep 2, 2006

• #2

your PIC is placed in the helicopter right? Then the Pulse Width Modulation is done by it to the DC motor.

 

J

josephkim87

New Member

• Sep 2, 2006

• #3

bananasiong said:

your PIC is placed in the helicopter right? Then the Pulse Width Modulation is done by it to the DC motor.

Click to expand...

hmm... PIC is placed in remote control side. But how to send the PWM by RF signal to the helicopter?

 

Nigel Goodwin

Super Moderator

Most Helpful Member

• Sep 2, 2006

• #4

Your question is really too vague to answer?, but any radio data link could quite easily send the data to the PIC, which then uses it to set the PWM level.

 

JimB

Super Moderator

Most Helpful Member

• Sep 2, 2006

• #5

At a quick guess, the radio does not send PWM, it sends a number which the PIC uses to set the mark/space ratio of the PWM.

JimB