^^ Simply awesome. I had hoped it would be somewhat easy. I had emailed the creator of the kit and I could swear it seemed like he knew less than I, I seriously doubt he was he he said he was.
I did purchase the kit and have already assembled it. I will disconnect LK1 first so that I do not forget haha.
The kit advertised that as-is, it allows 0-100%RPM, supposedly P1 is there because the voltage, even after R1 could get to the point of having the control circuit "skip" over itself, surpass 100% output and go back to very limited output. But I will take your advise on R1 and R7, especially with that part of the circuit now using only 0-5vdc range, thanks for their calibration advise.
Very exciting.
I'm worried about electrical noise though. I was looking over other google'd 0-5vdc controlled controllers (much more expensive industrial stuff) and I found it mentioned more than once that if 0-5vdc was used for control, an additional filter circuit had to be purchased. Do you think this kit is "noisy".
Thanks big time! I'm going to try to test this out today now that I'm home.