Hi, I'm new here and to electronics in general - so go easy !
For the past few months I've been wanting to interface my remote control car with my PC. I've found another project similar and he makes the schematic look pretty damn easy. The only problem is - I don't have a parrallel port.
**broken link removed**.
The controller is the same as used in this project:
**broken link removed**
https://www.drivemeinsane.com/howtos/rccar/rccar.shtml?theme=0
Connecting common and forward / back completes the circut and allows the car to move. So i'm looking for a Non-Parrallel way of doing this.
I've looked at: **broken link removed** And wondered if it would be any use to me. I was just caught by the "Digital/Analogue output"
So my questions:
Can it be done?
Can I use this board above?
Are there any alternatives?
Any help would be appreciated!
For the past few months I've been wanting to interface my remote control car with my PC. I've found another project similar and he makes the schematic look pretty damn easy. The only problem is - I don't have a parrallel port.
**broken link removed**.
The controller is the same as used in this project:
**broken link removed**
https://www.drivemeinsane.com/howtos/rccar/rccar.shtml?theme=0
Connecting common and forward / back completes the circut and allows the car to move. So i'm looking for a Non-Parrallel way of doing this.
I've looked at: **broken link removed** And wondered if it would be any use to me. I was just caught by the "Digital/Analogue output"
So my questions:
Can it be done?
Can I use this board above?
Are there any alternatives?
Any help would be appreciated!