DECLARE RSOUT_PIN PORT . PIN
Assigns the Port and Pin that will be used to output serial data from the RSOut command. This may be any valid port on the PICmicro.
If the Declare is not used in the program, then the default Port and Pin is PORTB.0.
DECLARE RSOUT_MODE INVERTED , TRUE or 1 , 0
Sets the serial mode for the data transmitted by RSOut. This may be inverted or true. Alternatively, a value of 1 may be substituted to represent inverted, and 0 for true.
If the Declare is not used in the program, then the default mode is INVERTED.
DECLARE SERIAL_BAUD 0 to 65535 bps (baud)
Informs the RSIn and RSOut routines as to what baud rate to receive and transmit data. Virtually any baud rate may be transmitted and received, but there are standard bauds, namely: -
300, 600, 1200, 2400, 4800, 9600, and 19200.
When using a 4MHz crystal, the highest baud rate that is reliably achievable is 9600. However, an increase in the oscillator speed allows higher baud rates to be achieved, including 38400 baud.
If the Declare is not used in the program, then the default baud is 9600.
DECLARE RSOUT_PACE 0 to 65535 microseconds (us)
Implements a delay between characters transmitted by the RSOut command.