1. Can a cell be programmed more than once? I define cell size to be 8 bytes because 8 bytes are programmed at a time. For example, if I program 0x55AA to a cell and again program 0x55AA to the same cell, is that allowed?
2. Once Flash chip is in erase/write enable mode, can it be read by dereferencing an address. Or do I have to command it to read mode in order to read. If it needs to be commanded to read mode in order to read, then do I have to put it back in erase/write mode in order to program.
1. Go to www.renesas.com
2. Under Find a Product - Click M32R
3. Upper Left Hand Side, click on documentation
4. Middle Left Hand Side, click on 32192/32195/32196 Group Hardware Manual
5. Then click on Hardware Manual
6. Go to Chapter 6.4 - Internal Flash Memory